Logo

What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?

Last Updated: 18.06.2025 02:22

What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?

Upvotes:

P = e* I, so since I is 16 amps, then the voltage dropped is 1/16 volt or 0.0650 volts.

This is a high voltage low current spike that comes down the line because of the power poles being struck, and the voltage suppressors activating on the primary side of the transformer.

Why do you have to be 18+ to go live on TikTok?

It seems Mohan does not understand the difference between a comment and an Answer.

These are simplified answers to the original question, and does not change anything I wrote above.

2024–10–16 [ OO OLAOYE OYEBODE ]

Why do men like BBW? What is the attraction?

Would individual surge supressors have save this equipment? most likely, since the surge supressor would take the jolt instead of the electronic components.

(Dc diagram shown, AC is similar).

The third is lightning and “how it gets conducted into a home.”

Why is it difficult to get a job?

nine

This is 'the assistant's answer'

This one hit behind the barn.

How did the Nazis figure out whether a person or community is 'Aryan' or not?

“ … to protect building, lightning arrestor, is provided above building and directly connected to earth.”

At one ohm, the resistor has a maximum of 1 watt power.

Once the voltage goes over 0.0650 volts, then this fact can be used to amplify the difference, and turn the circuit breaker off , furthur down the line. Essentially that is what a RCD/GFCI does, it compares the incoming current, to the outgoing current, and if the difference between the two currents is over 5mA, then it trips the circuit breaker.

What is a good way to conduct an interview?

2024–10–00 [ Ammar Mahdi ] Ammar Mahdi

2024–10–11 [Bobby Sanchez Bobby Sanchez ].

a photo is worth a thousand words.

Why is that Hag Hillary Clinton so quiet these days? She is the dog that isn't barking

so, the loop of wire then, when put together with another loop reduces the ‘noise’ on a power line.

Lightning arrestor is a spark-gap device, and can be installed anywhere. What is important, is that the wire is thick enough to withstand the lightning bolt and conduct the energy away from the building.

He then describes Rainy Season and Lightning.

Why do older siblings always hate younger siblings?

He then asserts :

This is an electronic circuit designed to clamp voltages so that the Voltage Potential that appears at the outlet is never going to exceed the nominal value.

He then describes the function of a fuse.

How do you say "have fun" in French?

What does a fuse do?

A fuse is a non-resetable over current circuit protector.

One is “what exactly is in a ‘surge protector’ ? ”

How old is planet Earth? Is it 4.5 billion years old or 6,000 years old?

So, the voltage could go up to 500 volts, and the fuse will not open up.

OK, this is Mohan Rajaratnam’s definition of a Surge suppressor.

Barnstars:

So I’m getting piano lessons and my teacher wants me to get an upright piano instead of a keyboard. An upright piano is way above my price range, so what do I do? And what’s the difference between an upright piano and a keyboard?

First Sentence:

An AC voltage/ current source, and an ac inductive load.

[image of Common-mode choke]

When the current is 200% of the rated value , it will “go open” (the link metal melts) and protect the device.

But it can get overloaded, and no longer works.

eight

what exactly is a ‘surge’ protector?

And this is the problem alone. Is the power supply in the equipmemt designed with a lightning strike in mind? Some yes, others, no.

Fuses, on their own, then operate much slower than the MOV variable resistance, during the lightning strike.

One

There are two important concepts here.

Is the question then , "why buy a surge supressor, if the fuse alone protects the electronic circuits from a lightning bolt?".

In schematic diagrams this is the symbol for a fuse:

So combined with a device called a MOV or Metal-oxide-resistor, then forms the 3rd part of a “surge suppressor “.

so, what happens?

These devices are installed between the “hot” and “neutral” and protective ground.

(There is no concept of polarity, in the loop because the current changes direction 100 to 120 times a second (power frequency).

2024–09–27 [ Mohan Rajaratnam Mohan Rajaratnam ] . Thinks you can get free electricity from nothing : Mohan Rajaratnam's answer to Is it possible to generate free electricity at home using a magnet or other low-cost methods? If so, how does it work?

Because the load is inductive, the current lags the voltage.(by a bit).

A circuit breaker is similar, but is resettable.

The MOV will conduct when the voltage exceeds 50% of line voltage.

The other is “what does a “fuse” do?”

This is the picture of an electronic coil of wire wound around a core of magnetic material.

This is where the MOV conducts again, and dissipated the energy.

2024–10–10[John johnson John Johnson ]

Now when you have a certain ac resistance, then a current flows in a loop.

What is lightning?

At least they know the answer if they wanted it.

Here is a simplified AC power diagram.

[old diagram got deleted by accident]

“ A surge suppressor is the one which is connected at the input supply so that when there is a sudden change voltage it bypasses thereby protecting the (circuit) and electronic components”

This is a photo where a lightning bolt took out a home's complete mains distribution box, and a lot of electronic gear as well.

2024–10–11 [Victor Olarewsju Victor Olarewaju ]

But… the neutral is now “floating” because of the 1 ohm resistance.

At the secondary, it is 1000 times less.)turns ratio). If it gets hit with a 100,000 volt bolt of lightning then the voltage arrestors conduct and clamp the voltage down to line voltage, ( but a small amount leaks down the line). This is the problem.

So, it’s possible that these devices from Trip Lite have addition suppression devices, these ones seem to be sturdy.

This is where this question deviates from being a 'generic' question, and becomes more specific.

2024–10–14 [Omar Gharbi Omar Gharbi ]

There is no harm in having the surge suppressor along with the fuse in the circuit. The fuse will not open up until the current melts the link. This will take time, and in the interim, that jolt will get transmitted into the power supplies.

Edit 2024–10.

but I think this circuit , shows a few more pieces.

This device then solves the entire problem.

The bolt then partially travels down the line to your home.

Mohan forgets that a fuse is a one-time device, and needs to be replaced if it is tripped.

“ A fuse is a device which protects the (circuit) against overload and short circuit.”

It also is a device that limits the change in current flow.

There are three different concepts here that are getting confused.

For this case there are devices called Metal oxide varistors (MOV).

Can the fuse protect the electronic devices from lightning instead of a surge protector.

It’s been three xxx five werks, and there has been no response to my follow on query on his Commment to my answer.

I post the exact comment here.

But during the surge, the fuse will not blow if it is a longer duration and lower value )10 to 50%).

the problem then depends on "how fast does the fuse operate?".

but this device (an Inductor) … impedes the rapid changes in the current.

If the nominal power is 4,000 watts then the current at 230volts is 16 amps.